Monthly Archives: April 2014

Assembly Starts

Well we have been busy cleaning the middle crank case section, flattening down the paint so it will be ready for paint when assembled.

April 27 004 April 27 002

Before we can start putting parts back onto the engine assembly stand, Pete did a great job of prepping the stand then etch prime , then a couple of coats of satin black.

April 27 001

April 27 008 April 27 009 April 27 010

The first section to go back on was the center section.

April 27 029

Next after cleaning the crank oil jets they were refitted. We are using 75/90 oil to lubricate all parts as they are fitted.

April 27 011

A good slug of oil fed into main center bearing.

April 27 014 April 27 013

 

Also plenty of oil down the center of the crank before fitting the end plugs.

April 27 012April 27 028

Next after a final wipe down, the front even row master rod and con rods were reassembled ready to be fitted.

April 27 031April 27 032

 

Before the con rods can be fitted the oil feed ring is fitted and lubed up.

April 27 030

 

That’s a good mile stone achieved, the even set of con rods fitted, time for a beer!

April 27 033

Next job was to clean the front maniton of little patches of surface rust.

April 27 034

Also we removed the maniton jet and cleaned it out ,April 27 035

Another little special tool was made from a 1/4″ drive extension to remove the jet.

April 27 036

 

We the aid of our third member of the team Mr. Engine Hoist the front maniton was refitted and lined up.

April 27 037 April 27 038April 27 039April 27 040

 

We have fitted pipe insulation to the con rods to protect them while the rest of the assembly is carried out, so when we are turning the engine and the con rods flop about there coating won’t get damaged.

April 27 041

 

The next job will be to fit and tighten the front maniton stretch bolts, this will have to wait to next weekend, as this will take three people to achieve the tension required!